EIGRP routing
| conf t |
| enter into configuration mode on the #central router |
| router eigrp 1 |
| set EIGRP routing with ID 1 |
| network 10.0.0.3 0.0.0.3 |
| set the network(s) to share. Netmask is reversed! |
| no auto-summary |
| reduce update packets and summarizes |
| end |
| sh ip eigrp neighbors |
| list eigrp neighbors |
| sh ip eigrp interfaces |
| list eigrp interfaces |
| sh ip protocols |
| detailed information of protocol setup |
| conf t |
| enter into configuration mode on the exterior routers |
| router eigrp 1 |
| set EIGRP routing with ID 1 |
| network 192.168.1.0 0.0.0.255 |
| network 10.0.0.0 0.0.0.3 |
| end |
| sh ip route |
| check route list on #central router |
| Additional, useful settings: |
| conf t |
| enter into configuration mode on #central router |
| router eigrp 1 |
| redistribute static |
| share static route for exterior routers. This is the only technical solution that EIGRP supports for sharing routes. |
| end |
| sh ip eigrp topology |
| list EIGRP topology |
| conf t |
| enter into configuration mode on #central router |
| int fa0/0 |
| ip bandwidth-percent eigrp 1 75 |
| limit interface bandwidth that eigrp can use for routing communication traffic |
| exit |
| router eigrp 1 |
| maximum paths 5 |
| limit the number of routing paths |
| exit |
| key chain cisco |
| creates a key chain and enter into key chain config mode |
| key 0 |
| configure key 0 |
| key-string cisco |
| int fa0/0 |
| enter into interface configuration. These settings are interface based. |
| ip authentication mode eigrp 1 md5 |
| set authentication mode |
| ip authentication key-chain eigrp 1 cisco |
| end |
Share with:
